It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one of these machines - but I just knew it could do fantastic stuff.

Along with the CNC router I discovered the wonderful material called Precision Board and the glues, primers and other companion products they offer. Since then we have gone through many tons of the material using it in most signs and projects we tackle. This journal will chronicle our many adventures both past, present and future. I'll talk from the perspective of someone who pushes these products to the creative limit on a daily basis. I'll be adding to the stories two or three times each week. -dan

Wednesday, February 22, 2017

Another load down the road

We loaded twelve large arches along with two large pallets of smaller pieces into the trailers on Monday and sent them on their way to NEBs Fun World in Ontario. We have more pieces finished and waiting until a few more are done before we send along another truckload.

We've completed two of the ten side arches. That leaves only eight more large pieces (of thirty-eight total) to go on this project. The side arches are a little different than the ones over the lanes as the bottom section is filled in. They also have oversize pennies instead of the number plates. The crew did an awesome job sculpting and painting the pieces!