WELCOME!

It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one of these machines - but I just knew it could do fantastic stuff.

Along with the CNC router I discovered the wonderful material called Precision Board and the glues, primers and other companion products they offer. Since then we have gone through many tons of the material using it in most signs and projects we tackle. This journal will chronicle our many adventures both past, present and future. I'll talk from the perspective of someone who pushes these products to the creative limit on a daily basis. I'll be adding to the stories two or three times each week. -dan

Saturday, June 8, 2013

Workshop in Bridgeton, Indiana


Last week I was in Bridgeton, Indiana, helping to teach a 3D sign workshop there. I was one of the teachers that included Peter Poanessa, Sandy Baird and Jamie & Jody Oxenham.  Rob & Deb Jones were our hosts who did a wonderful job!


With about 50 attendees it was a busy time with lots of sharing and learning all along the way.


The setting was beautiful with the centerpieces of the town being the covered bridge and the old mill - both spectacular attractions!




For those interested it is going to happen next year about the same time once again. May 29 - June 1, 2014. For information go to www.3Dsigncamp.com

-dan